Area Walls 22 Gauge | Standard Width
Area Walls and Grates (Standard Width)
Area Walls 18 Gauge Round (Commercial Grade)
Area Walls 18 Gauge Square (Commercial Grade)
Area Walls 18 Gauge Non-Egress Casement Style (Commercial Grade)
Area Walls 18 Gauge Egress Casement Style
Area Walls Grates and Ladders (Egress)
• Rolled top on all standard area walls
• 12”, 18”, 24”, and foundation vent area walls have rounded top and bottom corners for extra safety
• Stamped from single steel sheet
• Bright finish reflects light into basement
• Holes in flanges for bolting to wall
• Deep corrugation stiffens against back fill
• Minimum G-60 galvanized coating
• All back filling should be done gradually to prevent excessive pressure against area wall
| Standard Width 37” | Round or Straight Type | Galv. Steel | ||
| Model | Nominal Height | |
| AW12 | 12” | |
| AW15 | 15” | |
| AW18 | 18” | |
| AW24 | 24” | |
| AW30 | 30” | |
| AW36 | 36” | |
| AW48 | 48” | |
| Shipped: Wired Bundles of 5 | ||
| Foundation Vent Area Wall | Round Type | Galv. Steel | ||
| Width 19-1/2” | Projection 10” | ||
| Model | Nominal Height | |
| AWFV | 12” | |
| Shipped: Strapped Bundles of 10 | ||
Area Wall Grates | Standard Width
• Hot-dipped galvanized finish
• Grating type admits maximum light and air into basement
| STEEL GRATES | ROUND OR STRAIGHT TYPE | ||
| Model | Width | |
| AWGRG | 37” | |
| AWGSG | 37” | |
| GFVAWG | 19-1/2″ | |